Vehicle Fit Guide

Diagram of a car back seat showing where to measure rear-seat width, seat depth, footwell gap and headrest posts

Vehicle fit guide

Will it fit your vehicle?

The extender measures approximately 132 × 62 × 55 cm overall, with side protection panels around 38 cm high. Vehicle interiors vary between makes, models and seat configurations, so no back-seat extender fits every car and fit is not guaranteed for every vehicle. A few minutes with a tape measure tells you everything you need — compare each measurement below with the listed product dimensions before ordering.

How to measure

  1. Measure the width across the rear seat

    Between the door trims, along the seat base.

  2. Measure the seat depth and footwell gap

    Backrest to seat edge, then seat edge to the front seats.

  3. Check the headrest configuration

    The adjustable straps need suitable headrest posts or anchor points to attach to.

  4. Check rear-door clearance

    Make sure doors close freely once the seat is covered.

Vehicle interiors vary between makes, models and seat configurations. Check all listed dimensions against your vehicle before ordering.

Still unsure? The Back Seat Extender is covered by our 30-day fit guarantee. Carefully test-fit it after delivery and contact us within 30 days if it is not suitable. Conditions apply.

Measurement checklist

  • Rear-seat width measured
  • Seat depth measured
  • Footwell gap measured
  • Headrest type and spacing checked
  • Rear-door clearance checked
  • All measurements compared with the listed product dimensions

Measured up? You're ready.

The extender measures approximately 132 × 62 × 55 cm overall. Vehicle interiors vary, so compare your measurements before ordering — fit is not guaranteed for every vehicle.

Shop back-seat protection